Guide to Installing a Double Sink in Your Kitchen

Upgrading to a double sink in your kitchen is a smart move, whether you’re looking for more functionality or planning a complete remodel. A double sink simplifies multitasking by letting you wash dishes in one basin while preparing food in the other. While it may seem like a pro job, with the right tools and a step-by-step approach, installing a double sink can be a manageable DIY project.

Plan and Measure

Before you even purchase your new double sink, you’ll want to evaluate your current countertop and plumbing. Measure your existing sink opening to make sure the new sink will fit in the space or to determine if any countertop modifications are needed. If you’re upgrading from a single to a double bowl, you may also need to adjust or reconfigure the plumbing under the sink.

Gather Tools and Materials

Installing a double sink will require a few tools: a jigsaw (if you are drilling a new hole), a wrench, plumber’s putty, a bucket, Teflon tape, and possibly a new trap or drain kit. Be sure to wear safety equipment such as gloves and protective goggles. It’s also a good idea to have someone help you; removing and installing sinks can be a cumbersome and cumbersome job.

Removing the old sink

Start by turning off the water and disconnecting the pipes and drains. Position a bucket below to collect any leftover water. Carefully remove the old sink by loosening the clips underneath and cutting the sealant along the edge. Lift it out and thoroughly clean the area to prepare for the new installation.

Modify the countertop (if necessary)

If the new sink does not fit into the existing cutout, you will need to trace around it and cut it out using a jigsaw. Make sure you follow the safety instructions and double check your measurements – an incorrect cut could be a costly mistake.

Install the new sink

Apply plumber’s putty around the edges of the bottom of the sink. Gently set the sink into the opening, pressing down to create a tight seal. Fasten it underneath using the supplied clips or mounting hardware.

Connect the plumbing

This part can be a little tricky. You will probably need a double sink drain kit that connects both sink drains to a common outlet. Before tightening, check the alignment of the components. Wrap Teflon tape around the threaded fittings to prevent leaks and reconnect the water supply hoses.

Check for leaks and complete the job

Once everything is in place, turn the water back on and let it run through both sinks. Check all connections for leaks, tightening them where necessary. If everything looks good, remove any remaining plumber’s putty, seal the sink rim with silicone if necessary, and enjoy your new double sink!

Call Emergency Plumber in Darlington. We are 24 hours available.